Realizing 3 Layers Transport Model in the Communication Between Embedded System and PC

This article puts forward a 3 Layers Model for the communication between embedded system and PC. It is based on the speciality of them and the TCP/IP model. The model defines the communicate process of embedded system to be three layers: Transport Layer, Control Layer and Application Layer. Each layer serves for its higher-up. It can keep the efficiency and credibility of the communicate process and the authors prove and analyse that in the article. the concept of the model is also suitable for Bluetooth, IrDA and other kinds of communication about embedded system.     

A STUDY ON HEAT AND MOISTURE STATE OF HULL LAYER FOR THERMAL INSTULATION OF A COLD STORAGE

This paper analyses the thermal moist characteristics of the hull layer beside an air layer at lower temperature in an envelope for a cold storage and presents a new method of waterproof by air layer. With test data from engineering practice, the theory on the barrier of self moisture proof at the surface sublayer of the hull layer in an attic on a cold storage is proven. The dried zone about three phase point is confirmed. It is a new knowledge for thermophysics on thermal design of a cold storage with an optimum thermal performance.     

水平直元线犁体曲面的三维参数化设计

介绍了水平直元线三维参数化设计犁体曲面的方法,并利用其设计了相关的犁体曲面.与犁体曲面平面作图的方法相比较,该方法克服了犁体曲面平面作图设计的缺陷和不足,缩短了犁体曲面的设计周期,降低了设计费用,提高了设计质量,效果较好,为后续犁体曲面开发奠定了良好的基础.     

基于SHAW模型的冬小麦近地面层气温模拟

利用一维多层水热耦合SHAW（The simultaneous heat and water）模型,在田间实验的基础上,模拟河南省商丘地区2015年冬小麦拔节后近地面层0~40 cm垂直方向上的每小时气温变化特征。结果表明,冬小麦近地面层气温模拟整体效果较好,其中48%模拟的绝对误差低于1℃,75%模拟的绝对误差低于2℃,不同高度上模型效率ME均大于0.94;夜晚气温的模拟效果优于白天的模拟效果,白天11:00—14:00气温被过低估计,并随着近地面层高度的增加,模拟值误差越大;近地面层内3种气温特征值模拟效果的优劣依次为：日平均气温、日最低气温、日最高气温,其中,日平均气温模拟值与实测值基本吻合,日最低气温被略微高估,日最高气温被过低估计。此外,SHAW模型在冬小麦拔节后6个生育期的模拟效果均存在差异,拔节期、灌浆期和乳熟期模拟效果较好,孕穗期和开花期次之,抽穗期模拟效果相对较差。     

紫坪铺水利枢纽引水系统取消厂前伸缩节研究

结合紫坪铺水利枢纽工程的实际情况，采用三维有限元方法对该工程发电引水系统取消伸缩节的可行性进行了研究。计算结果表明，主厂房上游永久分缝处以一段垫层管代替常规伸缩节，结构位移和应力完全可以满足使用要求，从而达到了取消伸缩节、节省工程投资的目的。     

南方机引水田耖的研制与应用

水田耖是南方水田耕作中一种精细平整水田田面的机具,耖田作业是水田插秧前的最后一道作业工序。耖田质量的好坏不仅影响水田的灌溉、排水,而且影响插秧的质量和秧苗的返青速度。为此,根据南方水田耖田作业的农艺要求,分析了机引水田耖在田间作业的受力状况及影响耖田作业的主要因素,提出水田耖的结构设计要求,开发了1PJ-1.5型水田耖,并在实际应用中进行验证。     

基于隧道式发酵金针菇菌渣的双孢蘑菇培养料制备分析

采用隧道发酵技术,以金针菇(Flammulina filiformis)菌渣为原材料,进行双孢蘑菇培养料的制备。通过一次及二次隧道发酵的工艺控制,检测堆制过程中温度、含水量、pH及电导率等理化成分的变化,并结合出菇结果评价金针菇菌渣培养料的使用情况。结果表明,金针菇菌渣在隧道一次发酵过程中最高温可达74℃以上,整个发酵周期16 d。通过隧道发酵制备的二次培养料不黏腻、结构松散、味道清香,含水量为66.40%,pH为8.16,电导率为875.00μs·cm-1,含氮量2.00%,碳氮比为20.36,符合双孢蘑菇栽培要求。双孢蘑菇四潮出菇产量为19.25 kg·m-2。表明隧道式发酵技术可以应用于工厂化金针菇菌渣制备的双孢蘑菇培养料中。     

Short-Term Agronomical Effects of Olive Oil Pomace Composts on Pisum arvense L. and Trifolium subterraneum L. and Impacts on Soil Properties

Olive oil pomace (OLP) contains organic matter and nutrients that could be recycled by composting and supplying it to crops, solving the problem of disposal.

The effects of two OLP composts (C1 and C2) were assessed on two leguminous forage crops commonly cropped in the local livestock farms. In particular, C1 was applied on proteic pea and C2 on clover, compared with a mineral fertilizer (Min) and a commercial organic–mineral fertilizer (Org-min). The influence of composts on some soil chemical properties was also investigated.

The application of C1 significantly increased proteic pea dry weight at the end of the cycle by 27.2% and 52.0% and grain yield by 23.2% and 43.6%, in comparison with Org-min and Min, respectively. The clover dry weight during the entire cycle was lower in C2, in comparison with the other treatments, while no significant difference was found between C2 and the Org-min treatment both in yield and plant height.

Soil nitrate decreased from the beginning to the end of the trial in C1 and C2 plots by 22.8% and 50.9%, respectively. Soil phosphorous content significantly increased in Min by 32.4 and 41.7% compared to C1 and C2, respectively. These results showed that the substitution of commercial fertilizers with compost could be an environmentally sustainable solution. The high presence of heavy metals in compost should not affect soil application at least in this short-term trial.     

Effect of Aquasorb and Organic Compost Amendments on Soil Water Retention and Evaporation with Different Evaporation Potentials and Soil Textures

Abstract

Aquasorb PR3005A, a hydrophilic polymer (a salt copolymer polyacrylamide), and garden waste compost were added to a loamy sand and a loam soil in pots to assess their impact upon soil physical properties at two different evaporation potentials. Compost was mulched and incorporated, the Aquasorb was incorporated, and their effect on temperature and amelioration of soil water content and evaporation was investigated. Mulching with compost reduced evaporation and increased soil temperature. Maize (Zea mays var. single cross 704) was sown in the same pots later, and growth indicator factors (plant height, fresh and dry weight, root weight, and leaf area) were compared. It was concluded that compost mulch application is beneficial to soil water retention whereas compost incorporation did not show these benefits. Compost mulch advances seedling emergence and enhances early growth through hydrologic soil amelioration. High rates of Aquasorb were also beneficial in advancing the emergence and early growth of maize seeded in loamy sand. The hydration capacity of Aquasorb is reduced as the electrolyte concentration and electrical conductivity are increased. Increased electrolyte concentration in soil solution, through drying, may result in gel dehydration and water release at potentials greater than field capacity, which may be lost to drainage. Furthermore, it is concluded that pot experiments with amendments fail to simulate field conditions.     

热压温度对热压过程中板坯芯层温度变化影响的研究

纤维板热压过程中板坯芯层温度是否能迅速达到胶的固化温度是影响产品质量和生产率的重要因素之一。板坯热压过程中的传热速率受很多因素影响,如热压温度、板坯含水率、密度和厚度等,其中热压温度是生产中较易控制的工艺参数之一。通过探讨热压过程中板坯芯层温度变化规律与热压温度的关系,研究不同热压温度对板坯芯层温度变化的影响,为优化热压工艺条件提供理论依据。